Tips : Change your IP Address

There are many factors that require us to change the ip address. This is something that is not too difficult. Many methods that can be done, depending on how the system installed. Here are basic instructions commonly used.

Disconnect
Before entering into a specific operating system, you can try one of the two methods. First, disconnect the cable or DSL modem for a few minutes. Five minutes is usually sufficient to cause the IP address to reset when you connect to a modem and turn on the power. If not changed, try leaving the modem from an unplugged overnight. This has a good chance to work in number of cases. However, this is not a universal fix.

ShutDown
Click on Start, then Run, and then enter CMD. This will provide room to enter the phrase "ipconfig/release." Do not admit the quotes. After the system accepts this command, get into the phrase "ipconfig/renew." An alternative to try on windows is to shut down the computer after entering the "ipconfig/release" command. Leave the system off nightlong, making sure to switch off Ethernet and cable/DSL modems. Once you power up the system the following morning, the IP address should be reset.

Network On Router
Associate with the admin console on the router. Follow the instructions to release the IP address. This will vary, depending on the specs put in place by the manufacturer of the router. Power down the router, by on Ethernet and modems, and leave everything off overnight. Once the system is pulled back up the following morning, the IP address should be reset.

If all that fails
Whenever nothing you try changes the IP address, there's always the alternative of contacting your service provider and asking them to change your IP address at their end. These action can usually be accomplished in a relatively short period of time, or the service provider may be able to give you specific directions on how to switch the IP address that are unique to the provider connection.